The STILL RX60-20 forklift lead-acid battery needs to be stored carefully when not in use to avoid insufficient power when the forklift is used urgently. This type of tubular lead-acid battery has self-discharge and has strict environmental requirements. Please pay attention to the temperature during storage. Exceeding the range of -20℃～+40℃. The STILL RX60-20 forklift lead-acid battery needs to be stored in a charged state.
1. Understand the dangers of abnormally high temperatures
Before dealing with the abnormal high temperature problem of STILL RX60-20 forklift lead-acid battery, we first need to understand the harm of abnormal high temperature to the battery and forklift. High temperature will cause the electrolyte evaporation of the battery to increase and the internal reactions of the battery to accelerate, thus affecting the performance and life of the battery. In severe cases, it may cause the battery to overheat and even cause a safety accident. Therefore, timely handling of abnormal high temperature problems is crucial to the normal operation of forklifts.
If the lead-acid battery of the forklift is abnormally high, generates heat, smokes, etc., it is necessary to stop the forklift immediately and stop charging. It is necessary to further detect the battery, vehicle, charger and other reasons that can affect the high temperature of the battery. If the forklift battery continues to draw large current Discharge will cause the battery temperature to be high, the electrolyte will evaporate quickly, the plates will be burned, and the active materials will fall off.
Of course, the plates will age, which will increase the internal resistance of the battery. The internal resistance will generate a lot of heat during use, which will also cause the battery to be high-temperature. This There are potential dangers in the situation, and the battery must be replaced in time; there is also the problem of the forklift circuit board.
As we all know, the forklift relies on the battery as the driving force. Once the line fails, the battery current will also increase, causing high temperatures. Forklift drivers should often feel the temperature of the forklift battery with their hands. When the forklift’s lead-acid battery is charging or discharging, its own temperature should not exceed 35 degrees Celsius.
2. Proper charging of STILL RX60-20 forklift lead-acid battery
Low temperature will reduce the capacity of the battery. In a 50 F° environment, the battery will lose about 40% of its capacity. Therefore, the temperature of the battery room needs to be controlled centrally. The temperature difference between high and low should be less than 25-35°.
Forklift lead-acid batteries need to be stored carefully when not in use to avoid insufficient power when the forklift is used urgently. This type of tubular lead-acid battery has self-discharge and has strict environmental requirements. When storing, please be careful that the temperature does not exceed -20°C. ~+40℃ range. The STILL RX60-20 forklift lead-acid battery needs to be stored in a charged state.
Since part of the capacity will be lost due to self-discharge during transportation or during storage, please replenish the battery when using it. If it is left unused for a long time, please recharge it to make up for the self-discharge during storage. Replenish the power once a month. Storing it under conditions exceeding 40C will have a bad impact on the battery life, so please avoid it!
The forklift lead-acid battery has insufficient power. This situation is usually caused by battery congestion caused by incorrect charging and discharging. At this time, we should stop using the forklift, connect both ends of the battery to the discharge pile to discharge the electricity, and then plug in Turn on the power supply and fully charge it.
The forklift lead-acid battery cannot be charged, and the display shows that the battery is 0. Be careful at this time. First, take out the power supply and leave it in the open air for about an hour to release the static electricity attached to the original battery. Then try charging. If it does not work, you need to ask a professional Use the tools to open the battery box, remove the obviously bulging battery, and then connect the remaining batteries in order. In this way we will find that the battery can be charged and used again.
3. Handle abnormal situations promptly
Sparks appear in the lead-acid battery of the STILL RX60-20 forklift. In this case, you should stop and check immediately. Check whether the positive and negative connections of the battery are reversed. Then wipe the battery clean with a clean rag. If there are exposed wires, you need to replace them immediately. If the cause cannot be found, check and repair immediately.
Firsola provides lead-acid battery packs for various brands of electric forklift batteries, golf cart batteries, sightseeing cars, patrol cars, tour buses, tractors, solar energy, UPS, automobiles, ships, mining locomotives and other vehicle equipment. It is a leading supplier in Guangdong, China. A large battery manufacturing enterprise, professional and focused on high quality, long life is the last priority. Choose Firsola and you will not compromise on electricity consumption.
